![]() ![]() Through the SATA connector, a 2.5-inch hard disk can be installed, the Apple power supply with 10 watts that I use is sufficient for this. BitTorrent Sync on CubietruckīitTorrent Sync on CubietruckThe available CPU power can be used to install a BitTorrent Sync node on the Cubietruck. The result: instead of ~90% CPU usage by tvheadend on the (overclocked) Raspberry Pi, tvheadend on the Cubietruck only needs a good 30% CPU power. As before, tvheadend can be used to redistribute a TV signal from a DVB-C, DVB-T or IPTV signal in the network.Īfter tvheadend is installed, the equipment corresponds to that on the Raspberry Pi. Basically the new version works like the previous one - only the transcoding is not yet integrated in all versions and does not work under Mac OS X yet. Update : tvheadend 4.0.x releasedĪlready in May 2015 the new tvheadend version with the version number 4.0 was released. You can then call up the configuration via the tvheadend default port: replace "localhost" with the IP of the Cubietruck. That this works on every system is of course not guaranteed. deb file in the parent directory, which is then saved with dpkg -i tvheadend-*.deb can be installed.Īt my last attempt with the current version of, the package I created had no version number - but that's not a problem so far, it could be executed anyway. As a last resort./Autobuild.sh -t debian in the tvheadend directory.This will probably fail to find all the possible packages that you will need to install./configure until no more packages are missing. The current status Download from GitHub and unpack.If you want to build tvheadend from the current GIT repository yourself, you only have to do the following steps: tvheadend 3.4 for Debian Wheezy 7.3 on Cubietruck.Thanks to the available power it runs in a few minutes, I have built a package that is easy to install (without guarantee that it works on every system): ![]() The "solution": compile it by yourself, instructions are available on the tvheadend project page. TVHeadend 3.4 on CubietruckA problem occurred when installing tvheadend 3.4: the version for Raspberry Pi was not found via apt-get. Although a 15 Watt power supply is recommended when using a hard disk, the Apple power supply of the iPad 3 with 10 Watt manages to run the system stable.Īs operating system I rely on Cubieez Server in the current version 1.5 - the RAM requirement is very low by default, ideal for running additional services. The Cubieboard 3 or Cubietruck is, like all ARM-based Mini-PCs, very frugal in terms of power consumption. For the use with BitTorrent Sync the SATA port is ideal: in my case I connected a Hitachi HDD with one terabyte. The advantage: due to a Dualcore Allwinner A20 Cortex A7 SoC with 1 GHz as well as 2 GB RAM, the Cubietruck system has significantly more power than the Raspberry Pi. As my Raspberry Pi was too slow for some tasks, I needed something faster but still power saving: a Cubietruck or Cubieboard 3 was the solution for me. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |